Tipo Heat Exchangers Manufacturers, Cooling Towers Manufacturers, and Industrial Chillers Manufacturers

Heat exchanger in United Arab Emirates

The design of shell & tube heat exchangers includes several key components:

Channels

Channels in heat exchangers serve as entry and exit points for the tube-side fluids. They are designed to ensure uniform distribution of the fluid through the tube bundle to maximize heat transfer efficiency.  Pass-partition plates are used to direct and separate flows between each tube-side pass.

Tubes

Tubes are the primary surface through which heat is exchanged. Materials like carbon steel, stainless steel, duplex, and high-nickel alloys (Inconel, Hasteloy) are often used, typically selected based on factors like resistance to corrosion, temperature suitability, and overall cost . Low-finned tubes and other enhancements are available to increase the heat transfer coefficient as needed in certain services. Tube internals like twisted tape and wire inserts are also available and best used when exchanger performance or cost can be improved upon.

Tube Sheet

The tubesheet is a critical component that holds (fixes) the tubes in place, sealing and supporting them at the ends. Tubes are often attached to the tubesheet(s) via mechanical means using two-ring-grooves machined into the tubesheet holes, and then hydraulically (or pneumatically) expanding the tube into the tubesheet and grooves (aka, 2RG & Expanded).  Another common method is via a welded joint, typically considered a two-pass strength weld.  Single-pass seal-welds are sometimes added to expanded joints to minimize the risk of one process stream leaking into the other.

Tube Pitch and Layout

Tube pitch and layout is crucial, as it affects the overall heat transfer and pressure drop. Tube pitch is the distance between adjacent tubes (often 1.25x tube OD), and tube layout is the arrangement of the tubes relative to shell-side baffle flow, either triangular (30° or 60°), square (90°), or rotated square (45°).  Triangular layouts are cost effective and maximize performance relative to cost, but are more difficult to clean in shell-side services with heavy fouling.  Square pitch allows for shell-side mechanical cleaning, but generally is the most costly layout.  Rotated square layouts have some of the performance benefits of a triangular pitch, but with the accessibility of a square pitch. Tube pitch is often adjusted to balance heat transfer efficiency and pressure drop within the heat exchanger.

Shell

The shell is the pressure envelope of the heat exchanger. It contains the fluid that flows over (outside) the tubes. The shell’s configuration, including its diameter and length, is mostly a function of the bundle design.

Tie Rods and Spacers

Tie rods and spacers maintain the tube bundle’s alignment and support the baffle structure (aka, skeleton). They play a vital role in ensuring the structural integrity of the heat exchanger, but do not contribute to heat transfer.

Baffles

Baffles direct the shell-side fluid across the tube bundle, enhancing the heat transfer coefficient. They also help in supporting the tubes, preventing damaging vibration and wear. Single-segmental baffles are the most common, easily directing flow back and forth across the tubes. They can be cut and oriented so that shell-side flow is going side to side or up and down. When shell-side pressure drop (and velocities) are too high, double-segmental baffles can be used to reduce them both. Double-segmental baffles are almost always cut in the vertical direction in order to provide proper tube support. Helical baffles via a licensed technology like Lummus Helix changers can be used to leverage the available pressure drop, achieve higher shell-side performance, higher average velocities, reduced fouling, and reduced costs.